(704) 864 2470 info@nussbaum-usa.com


The UNI LIFT MAXX incorporates the NUSSBAUM NT hydraulic system with heavy-duty formed steel to create the finest alignment scissor lift in the world. This lift is the perfect solution for shops needing a precision alignment lift with larger capacity needed for todays trucks.

UNI LIFT 13000 Nussbaum Scissor Lift

UNI LIFT MAXX Heavy Duty Alignment Lift


An approved master/slave system guarantees the synchronization of both scissors units, while mechanical latches serve as security device. The UNI LIFT MAXX alignment lift is available for in-ground or above-ground installation. The high performance, oil-submerged power unit ensures a quiet operation and short lifting and lowering times.


  • UNI LIFT MAXX Alignment: Built in rear slip plates and turntable cutouts to accommodate the largest turn plates in the market. NUSSBAUM scissor alignment lifts have the lowest profile of comparable capacity scissor racks in the market.
  • Operating Performance: Powerful lifting with our industry only oil immersed motor. This powerful motor runs in the hydraulic fluid keeping it clean, cool and permanently lubricated for up to 5x the life of a standard bolt on power unit.
  • Increased Productivity: No mechanical connection between the platforms allows free access between the scissors
  • Platform Options: Available with flat or alignment ready runways
  • Runway Length: 236″
  • Installation: Can easily be surface mounted or installed in a pit
  • Flat and compact construction make the lift specially suitable for
    above-ground installation
  • “Safe-T-Lower” engages slow lowering and warning tone at 12″
  • Cylinders are hard chromed to increase durability and life
  • Uses less area than a similar four post, conserving valuable shop space
  • Mechanical locks standard for perfect alignment leveling at three positions
  • High performance oil-submerged power unit ensures a quiet operation and fast lifting and lowering times

UNI LIFT MAXX Accessories:

  • Pneumatic Joint Detector
  • Rolling Bridge Jack
  • Wheel Alignment Set


UNI LIFT 14000 18000
Lifting Capacity (lb) 14,000 18,000
Lifting Time Approx. (sec) 50 40
Lowering Time Approx. (sec) 38 40
Lifting Height (in) 74.875″ 74.875″
Drive-On Height(in)
Alignment Version
Runway Length std (in)
Long Runway
216.5″ 216.5″
Overall Length std (in)
Long Runway
282″ 282″
2 Wheel Alignment (in) 190″ 190″
4 Wheel Alignment (in) 170″ 170″
Overall Width (in) 99″ 99″
Width between Platforms (in) 37″ 37″
Motor (hp) 3.0 3.0
Voltage 208/230V / 1ph / 20 AMP 208/230V / 1ph / 20 AMP

Related Portfolio