(704) 864 2470 info@nussbaum-usa.com

UNI LIFT

The UNI LIFT incorporates the NUSSBAUM NT hydraulic system with precisely machined steel to create the finest alignment scissor lift in the world. This lift is the perfect solution for general repair, wheel alignment, test lanes and car reception areas.

UNI LIFT Alignment Lift Scissor

 

 

 

 

UNI LIFT ALIGNMENT LIFT FEATURES:

  • UNI LIFT Alignment: Built in rear slip plates and turntable cutouts to accommodate the largest turn plates in the market. NUSSBAUM scissor alignment lifts have the lowest profile of comparable capacity scissor racks in the market.
  • Operating Performance: Powerful lifting with our industry only oil immersed motor. This powerful motor runs in the hydraulic fluid keeping it clean, cool and permanently lubricated for up to 5x the life of a standard bolt on power unit.
  • Increased Productivity: No mechanical connection between the platforms allows free access between the scissors
  • Installation: Can be installed above-ground or in-ground
  • Flat and compact construction make the lift specially suitable for above-ground installation
  • “Safe-T-Lower” engages slow lowering and warning tone at 12″
  • Cylinders are hard chromed to increase durability and life
  • Uses less area than a similar four post, conserving valuable shop space
  • Mechanical locks standard for perfect alignment leveling at three positions
  • Available with flat or alignment ready runways
  • High performance oil-submerged power unit ensures a quiet operation and fast lifting and lowering times

FUNCTION & SAFETY

Two independent hydraulic circuits ensure safe and smooth lifting of the scissors. The fully hydraulic system requires no electrical or pneumatic components. A compact oil-submerged motor controls the UNI LIFT.

Perfect accessories for every application:
  • Pneumatic Joint Play Detector
  • Rolling Bridge Jack
  • Wheel Alignment Set
 

TECHNICAL DATA

UNI LIFT 9000 12000
Lifting Capacity (lb) 9,000 12,000
Lifting Time Approx. (sec) 27 35
Lowering Time Approx. (sec) 32 29
Lifting Height (in) 72″ 76″
Drive-On Height(in)
Alignment Version
7″ 7.5″
9.625″
Runway Length std (in)
Long Runway
165.375″ 197″
Overall Length std (in)
Long Runway
221.5″ 262″
2 Wheel Alignment (in) 190″
4 Wheel Alignment (in) 170″
Overall Width (in) 84.75″ 85″
Width between Platforms (in) 37″ 37″
Motor (hp) 3.0 3.0
Voltage 208/230V / 1 ph / 20 AMP 208/230V / 1 ph / 20 AMP

Related Portfolio